Brommerforum.nl - Print

Brommerforum.nl - Print: Reply

Deze reply is gepost in de afdeling Technical Forum in het onderwerp 'Krachten op frame door andere achterbrug (Mono)' (ID 48110).
De reply is geschreven door Royal Club (UserID 10377) op 20-2-2008 22:58.

Dit typt me pa even in het engels. ik kan het niet vanuit het japans begrijpen en in het nederlands vertalen

Due to stractural difference the stress value becomes diffirence at first.
And therefore the stres durability becomes difiirece, too.
The original frame design has been made with the normal swing arm = twin arms type.
If change the swing arm type from the twin arm type to the single arm type, then the stress value becomes difference.
The stress balance changes, too.
Above mentioned reason the original frame receives high or excessive stress, in results frame breakage and/or trouble will occurs in using.
When and how is difficult to say, but depends on the meant of the stress level and thier balance situation of the case.
Remember the original frame hase been designed and made for the twin rear arms with sifficient strength as well as dulability.
If changed it to the sevre stress specification as with the single arm type, the risk of problem sure becomes higer.

In the case of otherways around,replace them from the single arm type to the twin arm type, then the problem risk is small.
However the stractural balance changes, then the handling charactaristic will change, too.

geen spellingscontrole, houd r ff rekening mee